Schade das man als neues Mitglied hier im Forum direkt unter Generalverdacht gestellt wird. Hatte mich hier eigentlich nur angemeldet, da ich mich wieder vermehrt meinem in die Jahre gekommenen Hobby widmend wollte. Hierzu benötigt man natürlich erstmal neues passendes Material. Nach der Anmeldung habe ich mich im Forum umgesehen und bin auf den Post hier gestoßen. Da mich das Konzept überzeugt hat dachte ich man kann auch mal neuen Marken eine Chance geben. Aber gut vielleicht bin einfach zu euphorisch was die Wiederaufnahme des Triathlons angeht
Kannst Du bitte mal schildern wie das mit der Backofen-Nummer konkret abläuft? Finde den Schuh auch interessant, hätte aber Schiss beim erhitzen etwas falsch zu machen. 😉
The heatmolding process of our VENERATE shoes is fast, easy and very effective.
What you need: Shoes, socks, oven and a wet towel
Several easy steps:
-Preheat your oven to 80°C (175 °Fahrenheit).
-Mark your cleat position before taking them off your shoes. The insole can remain inside your shoes.
-Once the temperature is reached, place your shoes inside the oven and set a timer to 12 minutes.
-In case you have a special pressure point you can use a tissue or most other small objects and place them right onto the area where you have a pressure point. If necessary you can put some tape above to make sure it will remain in place. Then put on your socks.
-Once the 12 minutes are over you can take out your shoes and place them onto a flat surface in front of you.
-Step in carefully and use the atop system to tighten them to a comfortable tight fit.
-Make sure your knees are roughly above your toes and remain in this position for a couple of minutes.
-If you want to tighten the heel lock you should use your hands to apply pressure from instep and heel.
-To speed up the cooling down process use a wet towel to bring the carbon shell back to room temperature.
-That’s it! You can take the shoes off again, let them cool down for another couple of minutes and remount your cleats. Now all you need to do is go for your next ride!
Als alter Speedskater (damals wurden quasi alle Schuhe angeformt) kann ich berichten, dass das mit Socken an den Füßen durchaus erträglich ist. Bei meinen Bont war das auch nie ein Problem. So eng, dass Du sie barfuß anformen musst, will kein Mensch die Schuhe haben. Selbst wenn du barfuß fährst, braucht der Fuß etwas Spielraum.
Wir haben mal vor ein paar Jahren vom Sponsor solche Schuhe bekommen.
Fazit: Die müssen ab Anfang an einigermassen passen. Das Backen ist nur eine Nuancen-Anpassung. Die Leute waren nur bedingt zufrieden mit den Schuhen. Und das war das TOP-Modell.
Wir haben mal vor ein paar Jahren vom Sponsor solche Schuhe bekommen.
Fazit: Die müssen ab Anfang an einigermassen passen. Das Backen ist nur eine Nuancen-Anpassung. Die Leute waren nur bedingt zufrieden mit den Schuhen. Und das war das TOP-Modell.
War der sponsor venerate oder irgendein Lieferant thermoplastischer Schuhe der mit denen nix zu tun hat?